These limits are designed to provide reasonable protection against harmful interference in a residentia installation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions:Īny Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Key 11: Long press button 11 for about 3 seconds, the backlight flashes for 3 seconds and then stays on, the control box will memorize the current push rod position at the same time, the buzzer buzzes once and the backlight turns off short press button 11 again to push The lever moves to the memory position.
First gear: slower frequency intermittent vibration second gear: faster frequency intermittent vibration third gear: fastest frequency intermittent vibration fourth gear: continuous vibration four modes are switched in sequence within 30 minutes If there is no operation to change the button, the vibration motor is automatically turned off. Key 10: Short press button 10, the vibration mode is selected (there are 4 modes in total), when the vibration motor starts to work, it will switch from the original default vibration mode (intermittent vibration with slower frequency) to the first level, and press it again to gradually increase the cycle.Key 9: Short press button 9 to stop the push rod running to a fixed position (zero gravity mode) long press button 9 for 3 seconds, the current position is memorized (overwrite the previous memory), and the backlight flashes 3 times quickly, the control box bee Beep once after the position is memorized, short press button 9 to switch the fader to the current memorized position.Key 8：Long press button 8, push rod 2 retracts, release it to stop；.Key 7:Press button 7, short press button 7, push rod 1 and push rod 2 retract at the same time press any key to stop during the operation of the push rod.Key 3: press button 3 for 3 seconds, remember the current position (cover before memory), while backlight flash 3 times, control box buzzing 1 time Īfter remembering the position, press button 3, the bed body switch to BOOK position.Key 2: press button 2 for 3 seconds, remember the current position (cover the memory before), while backlight flash 3 times, control box buzzing 1 time Īfter remembering the position, press the button 2, the bed body switch to the viewing position.Key 1: press button 1, flashlight lit release button 1, flashlight extinguished.
0 kommentar(er)
